• Dual Cooling Fans
• Front Panel Speaker
• 25-pin Accessory Connector
• Adjustable Squelch
• 12.5 kHz/25 kHz Channel Spacing
• Over-the-Air Programming and Maintenance via DTMF Tone Sequences
• Built-in station CWID - Morse rate programmable 10-25 wpm
• The MAX TX POWER when transmitting 30Watts is ~8 Amps
• Quiescent draw is around ~250mA

Each dipole element is constructed with 6061-T6 aluminum, and welded at the base for maximum strength. Each antenna is also completely sealed with our high-tech Txylan™ coating, which resists water and ice buildup, and provides exceptional protection from corrosive gases, UV radiation, salt spray, acid rain and windblown abrasives. The phasing harness is fully sealed by Telewave’s Millenium Seal™ technology.

All components are at DC ground potential for lightning protection.

Wacom Duplexer WP652 (210-260 MHz) type 4 cavity pass-reject. Specifications

WP652 (210-260 MHz)

Type: 4 cavity pass-reject

Minimum freq. spacing      1.0 MHz

Insertion loss            1.5 dB/1 Mhz, 1.2 > 1.5 MHz

Max. continuous power     200 watts

Tx noise supp. at Rx freq.  85 dB/1 MHz, 90/1.5 MHz, 95/5 MHz

Rx isolation at Tx freq.      85 dB/1 MHz, 90/1.5 MHz, 95/5 MHz

Temperature range              -30 to +60C

VSWR                             1.3:1

Repeater Specifications

BCR-220 Repeater.

Specification: Introducing the ComLink BCR-220 FM Repeater System by BridgeCom Systems, Inc. built for Amateur Radio. The BCR-220 operates in 222-225 MHz (1.25m) range of the RF Spectrum. The BCR-220 is afeature rich repeater/base station. Packed with loads of RF power, this dual fan-cooled unit is an excellent

General BCR-220

Number of Channels: 16 Operating Voltage: 11 V DC Min / 13.8 V DC Nominal / 15 V DC Max Channel

Spacing: 20kHz/12.5kHz, Rated Current Drain: 11.2A Max, Weight: 18 lbs. Weight w/ duplexer: 20 lbs.

Frequency Range: 222.0-224.995 MHz, Dim. (W x H x D): 19.0? x 3.5? x 13.5? Frequency Stability: +/- 1.5 ppm

Operating, Temperature Range: -22? F to +140? F (-30? C to +60? C) Receiver BCR-220, Local Oscillator: Low-side injection, Sensitivity 0.25 ?V 12dB SINAD 0.22 ?V 10dB SINAD Squelch Threshold: Open 12dB

SINAD/Close 8dB SINAD Selectivity: 65dB @ 12.5kHz 70dB @ 20.0kHz Spurious Rejection: 70dB Intermodulation Rejection: 72dB @ 12.5kHz 72dB @ 20.0kHz Antenna Connector: N-Type Antenna Impedance: 50? Transmitter BCR-220 RF Output (w/o duplexer):

Programmable 222.0-224.995 0-30W Adjustable Modulation: 160K0F3E, 11K0F3E Maximum Deviation: +/- 5kHz (20 kHz) +/- 2.5 kHz (12.5 kHz) FM Hum and Noise 40dB @ 12.5kHz 45dB @ 20.0kHz Antenna Connector: N-Type

Turn-Key System: BCR-220 and Duplexer ? 1.25m (222-225 MHz) - 30 Watts Continuous Duty Designed and built in the USA Built-In 11.2A Power Supply Battery Backup with Built-in Charging Circuit Continuous Duty13.8 Volts Output Repeater Disable Function via DTMF remote control, Dual Cooling Fans,

Front Panel Speaker, External Speaker Out, LCD Display, 25-pin Accessory Connector: RX Discriminator Out, External PTT In TX Audio In +13.8V Out (1A Max), COS (Carrier Operated Switch) Output ,CTCSS/DCS Encode On/Of, Selectable Tx Preemphasis On/Off, Keypad Lock, Adjustable Squelch 12.5 kHz/25 kHz Channel Spacing Over-the-Air Programming and Maintenance via DTMF Tone Sequences, Adjustable RF Power

Transmitter Fine tuning - TX Voice and TX Sub Audible, TX Frequency, and CW ID Deviation Adjust TX Timeout Timer Per User Features: Air Time Logging Courtesy Tone (0, 500, 1000, 1500) TX Hang Timer Tone-In-Tail Selectable for quicker decodes Built-in station CWID - Morse rate programmable 10-25 wpm.

CSQ Repeat Carrier Operated Switch (COS) output - Valid signal or Carrier Connects to all your peripherals. Windows® Based Programmer (Sold Seperately) Meets FCC Part 15 class B standards - For Home or Office use 2 - year warranty, Windows® Based Programmer Screen Shot